Paver Installation Tips Pro Tips
Before hiring a company to do paver installation, be sure to check the Boca Raton Paving Company. Also, get at least three to five estimates before hiring a company. During the bidding process, ask them questions about the job, design, and overhead. If possible, get an estimate in writing so that you can make changes if necessary. During the actual installation process, be sure to ask questions as needed to ensure a smooth transition from the initial planning stage to the final project.
Make sure to prepare the base thoroughly. If you’re installing pavers over a sloping surface, a small amount of concrete must be poured on top of the soil. The concrete should not come more than halfway up the paver. It’s also important to have a sloped base that allows grass to grow up to the edges of the paver and stabilizes it. Make sure to get the concrete level with the soil beneath the pavers.
Prepare the paver base. A four-inch layer of crushed stone or a woven separation fabric should be spread evenly over the surface of the paver base. Add more layers as needed to achieve a uniform surface. Remember to keep a slope for drainage. For a more even surface, use a hand tamper or a plate compactor. Wear safety glasses and wear a hearing protection device while using either one. Before installing the pavers, lay down a layer of landscaping fabric to prevent weeds.
Once the base has been leveled and compacted, screeding the area is the next step. The screeding guides will help you in this process. It’s important to place screeding guides at proper intervals. The bedding sand should be sharp and angled to ensure that the paver is secured well into the joints. Then, place the paver installation guides on top of the screeding guide.
The shape of the project is largely dependent on personal preference. There are different types of pavers for different tastes, landscapes, and functions. Choosing materials based on your needs is crucial for a beautiful, comfortable patio. For example, irregular flagging offers a classic look, while smoother surfaces may be more appealing to guests. You can even have an irregular pattern in your patio if you choose to install pavers over concrete.
Before beginning with the installation, be sure to create a strong sub-base for the patio or driveway. This sub-base should be compacted with gravel or soil to ensure that there are no air gaps in the soil underneath. Otherwise, your pavers could end up sunken or raised. If you’re not careful, your pavers may become loose over time and not look as nice as they should. To avoid this problem, ensure that the sub-base is level before placing the paver installation.
Next, a level is necessary to ensure the sand is level. This is done by laying a few pipes of 3/4″ PVC pipe, each about one inch in outside diameter. You should start at the corner and work your way outwards, as if you were building a staircase. Afterward, you should lay a row of pavers, and then follow the path you’ve drawn with the screed pipes. If the pavers are not level, you can use a string or two-by-four to mark where the edges should meet.